Introduction to medium frequency bendMedium frequency pipe bender adopts medium frequency electric induction heating to bend the workpiece under the condition of local heating.Compared with the general cold pipe bender, not only does not need a complete set of special mold, but also the volume of th
27
2017-11
1. Check the water pressureWater pressure should be between 0.5mpa - 1.0mpa.2. Adjust the water pressure switchTwist the middle screw of the water pressure switch to adjust the water pressure to 0.4KgL/cm3. Check the direction of flow: specify blue water and water in red color.Host: blue color denot
03
2017-11
Although are now on the induction heating equipment operation instruction of cooling water for the "pure soft water", but restricted by conditions, and the user of equipment do not take the effects of using conditions, there will be many manufacturers use non-standard water quality.Even the water us
02
2017-11
How to select induction heating equipment?A complete induction heating system, its basic components include induction heating power, induction heating coil, heating workpiece and heating device.Xiang ning high and moderate frequency equipment limited liability company specializing in the development
25
2017-10
The advantages of induction heater1) induction heating is not necessary to heat the workpiece as a whole. It can be used selectively to heat the parts, so as to achieve the purpose of low energy consumption, and the deformation of the workpiece is not obvious. 2) the heating speed can make the workp
17
2017-10
150Kw handheld induction heating equipment has been tested well and being send to final customers.
10
2017-10
The inferior induction heating equipment can lead serious loss to enterprise
11
2017-09
Induction heating has characteristics and advantages over the traditional heating methods
30
2021-08
Why does high-frequency induction heating equipment produce process overheating? The overheating phenomenon of high-frequency induction heating can generally be divided into general overheating, fracture inheritance and small structure inheritance.